Anyone wire up a standard switcher in a PC10 dual monitor setup?

Teknotoyz

Well-known member
Joined
Aug 15, 2009
Messages
2,428
Reaction score
34
Location
BUFFALO, West Virginia
Anyone wire up a standard switcher in a PC10 dual monitor setup?

Has anyone installed a standard switcher into a Nintendo PC10?
Looks like it's 5v and 24v, but I'm thinking 24v only runs the coin counters which I don't need.

If anyone can confirm, it would help me out!
 
24v is just the coin counter. Dual Monitor PCB is 5v and the Single monitor is 5v and 12v.

Cut off the Nintendo plug and put on a standard 9 pin molex. Leave a few inches of wire so you can throw the original connector in a bag to save it for someone who demands to use the old Nintendo switcher instead of a nice new one.
 
24v is just the coin counter. Dual Monitor PCB is 5v and the Single monitor is 5v and 12v.

Cut off the Nintendo plug and put on a standard 9 pin molex. Leave a few inches of wire so you can throw the original connector in a bag to save it for someone who demands to use the old Nintendo switcher instead of a nice new one.

Thank you!
I plan to reuse the dead hulk of the old power supply, so no connector damage will ensue!
;)
 
Back
Top Bottom