Anyone have a WGE1995 running in CGA mode?

wsharp

Active member

Donor 2021, 2025
Joined
Jun 26, 2009
Messages
169
Reaction score
86
Location
Pennsylvania
Is there a manual PDF for this monitor around anywhere?

I just bought one of these and it's configured for VGA. A VGA cable is connected to the neck board as well as the main board with a small connector. The monitor also came with a short cable that looks like it would go from the main board directly to the neck board. Is this cable for CGA mode?

Anything else I need to do to get it working in CGA mode?

Any help is appreciated!
 
Thanks for the help.

There is a cable that runs from the small "VGA video" connector up the neck board at the "Video/From Cable or Main Board" connector. This was not hooked up when I got it but the monitor came with a small cable that goes here. At least CGA mode works when I have it hooked up this way. (Didn't try it without the cable).

In VGA mode, a several foot long VGA cable split its signals to the "VGA sync" part on the main head" and the "Video/From Cable..." part on the neck board.

The last problem I had was my Millipede was putting out negative composite sync on both pins for the monitor. The WG did not like that and was showing "over range" on the screen with both hooked up. Once I had just one pin connected for sync, I got a good picture.

Nice to have a stable monitor in my Millipede after fighting the original Matsushita for so long.
 
Yeah, the D9500 has been mentioned elsewhere here (by me) that you only connect one pin (horizontal) when doing the negative composite sync, regardless as to how the previous monitor liked it...
 
Back
Top Bottom