Anyone happen to have this Monitor remote PCB?

[Shawn1976]

It looks to be from a 19" KI-02-VO monitor chassie/ remote PCB.
It connects directly onto the chassie without any wiring.
If you happen to have this please shoot me a pm.
Thanks.

 

[Supergun]

That's a Kortek / Sharp Image monitor. I have one someplace, but it's for the 25". Not sure if they are compatible.

 

[mopar5150]

Kortek Link
Here is a pic of one (and a chassis) on ebay with a cable. Looks like the same adjuster board.

 

[RBLyon]

I have this one. Looks closer to the one in mopar5150 pic.

 

[Shawn1976]

I have this one. Looks closer to the one in mopar5150 pic.

I see the A behind the VO.
Anybody chime in thinking that is still ok to try?

 

[mopar5150]

The board looks correct, you may have to swap the connector. Or swap the connector on the chassis to match the cable.

 

[Shawn1976]

After looking at it more closely, I don't think its going to work.
That remote board has a 17-pin pinout where as the one I need is a 14-pin pinout.

 

[mopar5150]

Good catch.

 

[RBLyon]

Close but no cigar. Just checked, it does have 17 pins.

 

[Shawn1976]

Close but no cigar. Just checked, it does have 17 pins.

Really appreciate the effort of trying.
So the search is still on.

 

[Keithind]

I have this one. Looks closer to the one in mopar5150 pic.

Hello, RBLyon, I know it's been a couple years, but do you still happen to have that board? A couple knobs broke off of mine today. Please let me know. Thank you.

 

[RBLyon]

Hello, RBLyon, I know it's been a couple years, but do you still happen to have that board? A couple knobs broke off of mine today. Please let me know. Thank you.

Are you still looking for this remote board? I have been logged out for a couple of weeks and just now got this message. I will look to see if I still have it.

 

[Shawn1976]

Are you still looking for this remote board? I have been logged out for a couple of weeks and just now got this message. I will look to see if I still have it.

Yes please I am.
Any help you can give would be greatly appreciated.

 

[RBLyon]

Yes please I am.
Any help you can give would be greatly appreciated.

Pm you

 

[kryptronic]

@Shawn1976: I've got a complete Kortec 19" chassis with remote. 14 pin, correct model number. Pics below. It worked until I killed it with a brightness adjustment. It looked beautiful until it didn't.

PM me if you want the whole unit and make an offer.

FYI: This chassis seems to be a G07 drop in replacement. The tube should measure the same as a G07. I swapped in a G07 to replace the Kortec. I just needed to make a few connectors right. A rebuilt G07 from @tron guy might be the way to go.