Anybody have these midway parts.

chris25810

Well-known member
Joined
Oct 3, 2006
Messages
7,103
Reaction score
68
Location
lake elmo, Minnesota
Rating - 100%
178   0   0
Anybody have the metal board holder that sits on top of an mcr boardset? It's metal with a wood block that has slots cut into it to fit the board. It may also have a white warning label with red lettering on it. I also need the back door spring tensioner that holds the interlock switch. It's generally held in place by two screws on the piece of 1/4" back door stop.
 
I have both of these.
The wood portion of the board holder is not perfect. The wood that sits in between the boards has broken off in some places. I could probably cut a new one if needed.
PM if interested.
 
Anybody have the metal board holder that sits on top of an mcr boardset? It's metal with a wood block that has slots cut into it to fit the board. It may also have a white warning label with red lettering on it. I also need the back door spring tensioner that holds the interlock switch. It's generally held in place by two screws on the piece of 1/4" back door stop.

Just an FYI.....not all of those are the same (the wood slotted part). Some are slotted for the MCR stack with the metal pans...a la Spy Hunter, Timber, etc. The other is for the non-metal pan stack...a la Tron Kick, etc.

Edward
 
Just an FYI.....not all of those are the same (the wood slotted part). Some are slotted for the MCR stack with the metal pans...a la Spy Hunter, Timber, etc. The other is for the non-metal pan stack...a la Tron Kick, etc.

Edward


Thanks Edward, i knew that but didn't want to make the thread too confusing. I have one that i can use as a guide to cut a new block with the correct slots. The metal portion should be the same though.

The parts have been found btw, thanks everyone!
 
Back
Top Bottom