Arcadenut
Well-known member
Any Interest? Reproduction DL Control Panel and Brackets
I just had a Dragons' Lair Control panel reproduced along with the Marquee Brackets.
Is there any interest in making more?
The Control Panel as it sits right now would be around $175 if made in small quantities (5 or less), if more were interested, the price would drop.
The Marquee brackets would be $50 for the pair (upper and lower) and would have to be powder coated. I'll look into what it would cost to have them already powder coated.
These are not 100% the same, but pretty damn close. These are made from 16GA steel, the originals I believe are 18GA, which makes the reproduction thicker. The bends are a little more round because of this, but I don't think it would be an issue.
Here are the results:
Control Panel
Brackets
I just had a Dragons' Lair Control panel reproduced along with the Marquee Brackets.
Is there any interest in making more?
The Control Panel as it sits right now would be around $175 if made in small quantities (5 or less), if more were interested, the price would drop.
The Marquee brackets would be $50 for the pair (upper and lower) and would have to be powder coated. I'll look into what it would cost to have them already powder coated.
These are not 100% the same, but pretty damn close. These are made from 16GA steel, the originals I believe are 18GA, which makes the reproduction thicker. The bends are a little more round because of this, but I don't think it would be an issue.
Here are the results:
Control Panel
Brackets

