I used this particular version to try it out. Its a file I found online and I wanted to see how the laser cutter would do with it. I am in the process of tracing the plans available off Jakobud to use so that the artwork will match the cabinet. I have so far Mortal Kombat, Galaga, Donkey Kong, & Pacman. These are pretty much puzzels that you can assemble with a little wood glue and tape to hold it till dry in roughly 10 or 15 minutes. So far I only put a slot on the top (your not supposed to take the money out of the bank!!!).The ones I am trying to do will have the sideart, marquee, coin door (may not be the correct coin door), some form of kickplate artwork if applicable, and something where the monitor would be. I was thinking people could have me put high scores on the monitor of something like that. I will be cutting these tomorrow morning and will post some pictures of how they turn out. I am also thining of doing some pinball machines any suggestions are welcome.