The amplifone has everything, yoke, harness, PCB boards, bracket
It's one complete amp setup and two NOS tubes
I think most folks were confused by 'one complete Amp setup', meaning it included the tube. (I'll admit I was as well, so thanks for clarifying).
As for my 2 cents, I'd say $750-800 for the full setup with no tube. ($250 per board, plus $250 for the yoke, if all have been rebuilt and tested). Personally I think $1k is on the low side for a complete Amp. Yes, they've sold for that, but I think the market can go higher.
The tubes I'm not as sure on. What model tubes are they? There are multiple tubes that can be used with Amps, so perhaps one could argue they aren't as rare as 6100 tubes (which I've sold several of for $350 each, recently). But the fact that they're NOS partly makes up for that. You you should provide the model numbers though, as med vs low res will affect the value.
If you want to sell them, post them for higher than what you think, and come down weekly until they sell. That's really the best way to figure out what the market is willing to pay.