Afterburner Shaker Motor Question

mcplus

Member
Joined
Jun 24, 2005
Messages
156
Reaction score
6
Location
Indiana
I just replaced the little board that controls the shaker motor on my Afterburner as it was thought that was the reason the motor would not work. I put it in to motor test in the test menu and when I go to change the motor from "off" to "on"(by hitting the vulcan trigger) as long as I keep the trigger held on it says "on", but as soon as I let off the trigger it toggles right back to "off"? All the wiring on the motor "appears" intact, so I am wondering if the board I picked up is working? Sorry if this has been asked before but I searched and could not find anything. Thanks
 
It's a relay board.

Did you check the fuses in the cabinet, and the circuit breaker(s)?
Have you verified the power is getting to the relay board?
 
my boardet is messed up, it wont even let me get as far as you can.

If you can manually command the shaker to work then the curcuitry is fine.

check the dipswitch settings,(you have to pull out the pcb stack to do this) the cabinet type may be set wrong, or shaker might be set to off( not sure if thats an option or not)
 
Back
Top Bottom