You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Museum of the Game® & International Arcade Museum® Forums
Hello! I recently purchased a WG K5500 chassis to replace my aging one. Problem is, I hooked it up and got a picture only in the center of the screen and trying to adjust the V. Size causes the picture to fold over. It doesn't reach the edges of the screen seemingly no matter how much or what I adjust. I haven't tried the horizontal width coil yet, assuming that will only help with the horizontal width. Here's some pictures of the problem and the chassis. I'm new to this sort of thing--I generally can label the parts, remove and hook up a chassis, etc. but haven't run into this particular issue where I can't get the picture to reach even the sides of the screen. Any and all help is greatly appreciated!
PICTURE of the vertical distortion when V. Size is increased
PICTURE of V. Size lowered until the vertical distortion went away