Tighe Well-known member VAPS Joined May 25, 2009 Messages 20,797 Reaction score 825 Location Richmondville, New York May 12, 2012 #1 Can this be done? The picture is about 3/4" too high. I know there is a pot on the remote board of k7000s for this... I don't see one on the chassis.
Can this be done? The picture is about 3/4" too high. I know there is a pot on the remote board of k7000s for this... I don't see one on the chassis.
mrbill2084 Well-known member VAPS Joined Oct 6, 2005 Messages 12,572 Reaction score 1,518 Location san jose, California May 12, 2012 #2 there is a 3 position jumper to the left and behind the 2 cards. look at the manual on page 18 if you cant find it. http://www.arcade-museum.com/manuals-monitors/WG K4600_Manual.pdf
there is a 3 position jumper to the left and behind the 2 cards. look at the manual on page 18 if you cant find it. http://www.arcade-museum.com/manuals-monitors/WG K4600_Manual.pdf
OP OP Tighe Well-known member VAPS Joined May 25, 2009 Messages 20,797 Reaction score 825 Location Richmondville, New York May 12, 2012 #3 Thanks! I was able to move it some, not as much as I would like.
OP OP Tighe Well-known member VAPS Joined May 25, 2009 Messages 20,797 Reaction score 825 Location Richmondville, New York May 13, 2012 #4 Is there anything else I can do to adjust the picture?
modessitt Volunteer: Encyclopedia Submission Moderator VAPS Joined Mar 22, 2007 Messages 33,414 Reaction score 325 Location Austin, Texas May 13, 2012 #5 Sometimes the hold put will let you move it some without losing hold...