mrsodapop
Active member
Ok I have a A-One AM0629, I'm doing a cap kit and watching reruns of Miami Vice(I love this show!). Not paying attention to my work - I know I know stupid move- so I remove C35(10uf/50v), than go to install new one and find it is not marked as to which hole is -neg. and I did not see how the old one was oriented !
How do I find out which hole is neg.? I tried using DVM to see if one was connected directly to ground circuit, but that was a dead end, than tried to find schem. online,and that was a dead end. Any Ideas?
Thanks for any help
Aaron
How do I find out which hole is neg.? I tried using DVM to see if one was connected directly to ground circuit, but that was a dead end, than tried to find schem. online,and that was a dead end. Any Ideas?
Thanks for any help
Aaron