A Little Help with a Gauntlet Restoration?

MagicMarc-er

Member
Joined
Apr 14, 2011
Messages
404
Reaction score
21
Location
Worthington, Ohio
I bought a Gauntlet Cabinet/Monitor and replaced the boards and control panel. I'm now starting to wire the display but am having trouble figuring out a couple of the pins. There are two square pin male connectors on the display board. One is 6 pin and one is 3 pin. They are side-by-side. The wiring diagram shows what to do with the 6 pin but not the 3-pin. Anyone have a Gauntlet that they could take a look at and let me know what those 3 pins connect to?
 
I don't have the manual here, but I'm assuming you're talking about how to hook up your monitor pcb. If the 6 and the 3 are side by side, you likely have an Electrohome G07 monitor. I am NOW going to assume that Gauntlet is a positive sync game, lol.... so with all those assumptions, you probably only have to hook up the 6 wire connector on the wiring diagram.

The other three connections are to hook up "negative sync" gameboards... if Gauntlet is a positive sync gameboard, it would hook in through the last two pins of the 6 pin connector.
 
That sounds right. The wiring diagram in the manual makes no mention of the 3-pins only the 6-pins. I'm not setting this up as a MAME, just returning it to it's original configuration so I'll disregard those extra pins as you suggested. [fingers crossed]
 
Back
Top Bottom