60n 1 with wg4600

chas010

Permanently Banned
Joined
Aug 23, 2008
Messages
1,341
Reaction score
2
Location
Waterloo, New York
I just recapped my 4600 and it looks great running a Gemini wing jamma board but has a slight curl on the right side of the screen with my 60n 1. It has the 317 video board and both pos and neg sync hooked up. Should I try removing one sync or the other? the curl wont adjust out and its ever so slight but drives me nuts.
 
make sure your ground wire isnt on the pin near the red green blue video wires. it should be on the ground near the neg white sync pin wire input.

try adjusting the red potentiometer in the metal can accessed from the side of the daughter card for that curl.

ken L. said once that resistor R352 is starting to go bad on that same card. take it out and test it.
 
Last edited:
Thanks guys, the kit from bob roberts came with a new resistor for r360 that initially I didnt install. After installing it (different value than origional resistor) it looks good.
 
Back
Top Bottom