60 in 1 problem

XY4u

New member
Joined
Sep 6, 2006
Messages
287
Reaction score
3
Location
Kansas
All of the LEDs in the picture are on steady with power from test jig. No video out. Anybody have any ideas? Can you fix these or are they disposable?
 

Attachments

  • 60 in 1 edited.JPG
    60 in 1 edited.JPG
    22.7 KB · Views: 15
5.08 v. Do they neded to run at a higher voltage??
 
I bumped it up to 5.12 measured on the board and still nothing.
 
Try video with jamma cga monitor? Or are you using a VGA monitor? There is a dip switch to change between the two monitors I believe, at least I read something about that. Could have been on the 19-in-1...
 
Unplug everything but the power and try again. Nothing is blinking? Usually an orange LED blinks as it boots then goes to blinking green...
 
I'm using the VGA out. i don't know which dip sw changes it to RGB. I unplugged everything and powered up again and all LEDs on steady.
 
reseated and powered. All LEDs on steady. Bummer
 
Back
Top Bottom