FS Parts: 4x Nintendo PCB to Jamma Adapters

Malice95

Well-known member

Donor 2011
Joined
Aug 29, 2010
Messages
3,692
Reaction score
31
Location
Howell, New Jersey
Rating - 100%
79   0   0
I have 4x Clay Cowgill Nintendo PCB to Jamma Adapters up for grabs.
I had planned to use these but plans changed. These provide
full jamma connectivity for Nintendo boards.. Audio, inversion, etc.

http://www.multigame.com/nin2jamma.html

Clay sold these to me for $40 + shipping..

I'll sell them for $35 shipped each.

Thanks,
Mike
 

Attachments

  • photo.jpg
    photo.jpg
    41.1 KB · Views: 44
Who makes adapters to play Jamma Boards in Nintendo cabs? Does any one know?

These are the opposite, allowing nintendo board to play in jamma cabs right?
 
Who makes adapters to play Jamma Boards in Nintendo cabs? Does any one know?

No one ... yet. There have been a few requests for this lately so maybe someone will look into it.

These are the opposite, allowing nintendo board to play in jamma cabs right?

Correct!
 
Yeah, I wanted one as well

Who makes adapters to play Jamma Boards in Nintendo cabs? Does any one know?

These are the opposite, allowing nintendo board to play in jamma cabs right?

I couldn't find one. I have a DK Jr Cocktail that I am putting a 60-in-1 in and dont want to hack up the wiring. My monitor has the inverter/non inverted circut, so I'm using a Jammaboards.com fingerboard in the Nintendo harness to connect to everything.

I'm hoping it ends up working. But would have paid to have it plug-in-PLAY!
 
I couldn't find one. I have a DK Jr Cocktail that I am putting a 60-in-1 in and dont want to hack up the wiring. My monitor has the inverter/non inverted circut, so I'm using a Jammaboards.com fingerboard in the Nintendo harness to connect to everything.

I'm hoping it ends up working. But would have paid to have it plug-in-PLAY!

You'll need to use a switching power supply as well if I remember correctly. If you're going to go through all that work with a fingerboard you might as well wire in a jamma harness with a switching power supply and leave the existing wiring as is. That way you can always go back to it being a nintendo cocktail. The new jamma wiring shouldn't take up much room in there. Just tie off the existing wires and label them.
 
Back
Top Bottom