48-in-1 won't boot

Fatsquatch

Active member
Joined
Dec 28, 2001
Messages
2,325
Reaction score
5
Location
Tennessee
When powering up my fairly new 48-in-1 board, it fails to boot. I get nothing on the screen, and on the board itself, LED1 is red, LED2 & 3 are yellow, and LED5 is green.

What's the likely problem?

(I'm running the board in a dedicated Pac cab with the LizardLick adapter.)
 
When powering up my fairly new 48-in-1 board, it fails to boot. I get nothing on the screen, and on the board itself, LED1 is red, LED2 & 3 are yellow, and LED5 is green.

What's the likely problem?

(I'm running the board in a dedicated Pac cab with the LizardLick adapter.)

Power supply is bad or JAMMA connector isn't on properly (or it's not actually a JAMMA connector).

Ah, didn't see the LL Pac adapter. I know there have been some problems with it before. Do a search here for lizardlick...
 
you checked / tested for voltages ?

also you have the right setting for the monitor your using? did it used to work, or is this a new install?
 
Its been working fine for a couple months; just wouldn't boot up as of yesterday.

The original Pac boards work fine.

I wouldn't be surprised if that LizardLick adapter bombed out, taking the 48-in-1 with it.
 
My friend has a LL and 60-1 board in his pac-man and his went out the other day. On his, it was the test switch inside the coin door - his kids were used to using the credit switch before the new board was put in and must have bumped it. For some reason, the test switch never worked correctly and when in the test mode, the board won't boot. Give that a shot.
 
Back
Top Bottom