4600 with pic too high

treborlicec

Well-known member

Donor 2016
Joined
Nov 4, 2005
Messages
6,167
Reaction score
182
Location
Indiana
Wired up a 60 in 1 to a cab with a 4600. Adjusted the horizontal adjustment and the pic looks super clear. It is just too high. Or since it is mounted vertically, it is too far to the right when facing it. The part that you lose on the right appears on the left, so it is completely shifted. No cap kit or anything on this. Worked fine with a different non jamma game just hours before.

Any ideas?

I haven't messed with any other 4600's.

Thanks,
 
not having the sync combined on the video header will cause this to happen on a 4600 with a xx-1 game board

I have it set up with negative composite sync. I moved the vid ground from the rgb connector to the sync connector. Same result either way. I can take pix after work if needed.

Thanks,
 
try shifting the 3 pin connector over 1 pin to only connect with the -h sync and see what happens.

pics would be great, but it sounds like a sync issue
 
Looks like that did it. Never worked on a 4600 before. Those cards are different. Thanks.
 
Back
Top Bottom