4600 metal chassis part needed

toolguy

New member
Joined
Apr 6, 2010
Messages
1,616
Reaction score
17
Location
Michigan
Rating - 0%
0   0   0
Does anyone have the horizontal metal part of the chassis frame for a WG4600?

I just need the bottom tray so to speak, that holds and PCB and cards. This tray joins the two metal sides together.

Hope I'm making sense here!

Thanks,
 
Does anyone have the horizontal metal part of the chassis frame for a WG4600?

I just need the bottom tray so to speak, that holds and PCB and cards. This tray joins the two metal sides together.

Hope I'm making sense here!

Thanks,

Actually it's more like 2 metal bars that goes between the two side pieces.
 
Actually it's more like 2 metal bars that goes between the two side pieces.

Oh Ok, see that's what I did not know...

The monitor was replaced with this 4600, it came with a G07. So I was not sure how the 4600 was held in place. Right now, its screwed to the wood on under the tube more or less.

Guess maybe I should search for a G07 horizontal piece then and try and get the 4600 PCB to fit it?
 
Last edited:
Oh Ok, see that's what I did not know...

The monitor was replaced with this 4600, it came with a G07. So I was not sure how the 4600 was held in place. Right now, its screwed to the wood on under the tube more or less.

Guess maybe I should search for a G07 horizontal piece then and try and get the 4600 PCB to fit it?

Heck if the wood works just use that, besides wood is non-conductive. If you end up going with the G07 tray the 4600 metal PCB frame has 2 screw holes on the left but you would have to drill 2 more on the right side to secure it.
 
if these are what you are looking for let me know

SSPX0855.jpg
 
Looks like I need a G07 horizontal tray chassis piece because the two metal chassis sides are from the orignla G07. I would then have to make my 4600 PCB fit the G07 tray piece.
 
Back
Top Bottom