No pics yet, sorry. I have to run out the door!
Anyways, we got them home with no issues. The 2 driving games were in a cellar environment, so they had some water on the very bottom, and stink a bit.
Badlands, no input yet. I pulled the monitor that appeared to work. I pull the jamma pcb and test it in another cab.
Outrun: "It worked last time..." my ass!!! The monitor had no HV. The badlands monitor was the same WG k7900 model, so I swapped them out. After dialing it in, I had a decent picture on the outrun, but it needs capped. First thing I noticed - no steering. Opened it up, and that damn plastic driveshaft gear was in about 20 pieces - hence the "worked last time my ass" comment. Anyone have one of those gears, or know where I can get one without bending over too far?

I tried to manual activate the steering, but the pot did not register anything. Bad pot I assume??? Pedals, shifter, and start work perfectly fine.
Paperboy: Everything powered on when I first got it. Monitor was just a white screen. The CPU LED was lit up, but the video board was not. There is a replacement switcher in there to feed only the +5, which tested out to 5.07 Volts. Why would the video LED be off?
As I was peaking around at the power supply, I noticed the marquee light power cord was unplugged. I turned the game off and plugged it in. When I turned it back on, I saw a spark down at the base of the transformer, then everything died. When I turn on the switch now, there is absolutely zero life in the cab - even when I unplugged the marquee to the way it was. I checked every fuse and they 'looked' okay. Didn't get a chance to test them yet.
The current plan is to clean up the Outrun and get it 100% first. I need a gear and I assume a pot for the steering wheel. Pics will come later tonight.