24 opto board component question

ModCity

Active member
Joined
Aug 11, 2010
Messages
362
Reaction score
30
Location
Freeman, South Dakota
My BSD has had an on-again, off-again ball miscounting problem that appears to be centered around the 24 opto board. We checked it out, and the inductor at L1 has a broken lead going to the board, apparently a common problem with this board.

I don't see a lot of repro boards out there - at least not at Marco, the only place I've really looked so far.

Does someone know the specifics on the L1 inductor? The manual just says 10uH. Or does anyone know what would work properly here?
 
Back
Top Bottom