FS Parts: (2) wico 8 way leaf sticks-NOS grommets

tron guy

Super Moderator
Staff member

Donor 12 years: 2011, 2015-2025
Joined
Jun 26, 2007
Messages
23,144
Reaction score
2,592
Location
Eureka, California
Rating - 100%
383   0   0
I just took these apart cleaned the gunk and dust, etc. out of the bases, installed NOS grommets and here they are.

Pretty nice sticks (IMO)
red ball tops are good, I showed pictures of the little tiny spot I seem to see on every wico ball top

$75 shipped for the pair-priority mail


SOLD
 

Attachments

  • 001.jpg
    001.jpg
    83.8 KB · Views: 42
  • 002.jpg
    002.jpg
    85.2 KB · Views: 34
  • 003.jpg
    003.jpg
    91.5 KB · Views: 48
  • 004.jpg
    004.jpg
    89.9 KB · Views: 45
  • 005.jpg
    005.jpg
    86.3 KB · Views: 33
Last edited:
In trade I would consider a mario bros widebody bezel and marquee (in reasonably good shape) not below average.

I don't think my price is out of line, if you do, shoot an offer.
 
Those sticks are squeaky clean...probably just a matter of someone needing a pair to snatch them up. With NOS grommets they are as good as new, too.
 
Can't tell from the photos... are those 3.5" or 4" shafts? My Robotron sticks are pretty nice but they are 3.5" shafts. Someone gave me two repro 4" shafts but I'm too lazy to tear them down to rebuild them, and the ball tops on the repros are kinda dull and worn looking anyway. Also, the leaf switches on mine are gettin' pretty beat up and may not last much longer.

I happen to have an extra widebody Mario Bros. bezel that's in decent shape, and a bottle of Novus plastic polish to try out on it is sitting here on my desk. Don't have a marquee though.
 
Last edited:
I measured from stick end to the base of the ball and it was 3 1/2".

Dude to put those 4" sticks in all you have to do is remove the c-ring, pull out the stick, making sure that you catch the actuator and little spring. Put the 4" stick in, spring, actuator, c-ring. done


SOLD
 
Last edited:
Dude to put those 4" sticks in all you have to do is remove the c-ring, pull out the stick, making sure that you catch the actuator and little spring. Put the 4" stick in, spring, actuator, c-ring. done

Sounds easy, thanks. I'll give it a go. And I can replace the translucent red buttons with translucent blue buttons while I'm at it. My Robotron will be back to normal then.
 
Back
Top Bottom