19n1 button and wiring question...

falcon114

New member
Joined
Dec 6, 2017
Messages
8
Reaction score
0
Location
Arkansas
hey folks,

i've got an old horizontal monitor cabinet that i'm going to add a 19n1 board to and i'm not sure about the wiring harness. will a standard jamma wiring harness work for this board or will i need something different? with all of the extra buttons i am unsure of the setup and would like to get a head start on this before my board arrives.

any advice or suggestions?

thanks!
falcon114
neal
 
The board uses a standard Jamma harness, but to use all the buttons, you need to follow the instructions and wire up the extra buttons for games like Defender and Stargate.

Also, if you have one of the older generation boards, I think it was button 6 will not work because the pin on the board doesn't go to anything.
 
The board uses a standard Jamma harness, but to use all the buttons, you need to follow the instructions and wire up the extra buttons for games like Defender and Stargate.

Also, if you have one of the older generation boards, I think it was button 6 will not work because the pin on the board doesn't go to anything.

so there are actual instructions with these boards? unlike the 60n1's that just have dip settings and such? does anybody know where these might be online?

thanks for your help!
 
Back
Top Bottom