19K4901 with nintendo iso?

sk8ersublime

Well-known member
Joined
Mar 7, 2010
Messages
2,067
Reaction score
62
Location
Frederick, Maryland
I just got a WG 19K4901 and I was wondering if it will work ok using the ISO in my nintendo cab. The manual for it says 108v-132v, so the 100v iso should work correct?
 
I actually just tested this set up with my multimeter, and I'm getting 122V out of the wall and to the PS. And 109.7V from the ISO. This is fine for a sanyo right? I don't wanna kill it if I decide to get one.
 
Is that loaded? Technically, I believe the Sanyo specs say max is 110V. If you are worried about it you could use the other taps out of the transformer to bring the voltage down.
 
Sometimes a load will make it drop.

Also, that ISO, like a lot of other transformers used in vids, has 3 taps. So, if you move one wire over it will use another tap. Depending on which one you use and are currently using, it could bring the voltage down further or even make it 1:1. Take a look at just about any of the Nintendo manuals.
 
Ok I'll take a look. I just tested the iso in my Mario widebody with a sanyo an it's reading 109V with the monitor out and 108V with the monitor plugged in.
 
Back
Top Bottom