19K4606 VR201 pot part number

delroy666

Well-known member

Donor 2011
Joined
Jul 30, 2009
Messages
1,189
Reaction score
26
Location
Ottawa, Ontario, Canada
I'm currently trying to repair the WG 19K4606 monitor that came in my Pac cab. Besides doing a 'cap kit', I need to replace the VR201 pot on the interface board. (I checked with a DMM) Does anyone have a Digi-Key/Newark/Mouser etc. part number handy for this pot? I think this is included in some cap kits, so hopefully someone does. I looked through my Digi-Key catalogue but couldn't find one with the same footprint.
 
Last edited:
mouser 531-PT15D-2.5K

Excellent, thank you!

Bob Roberts has these pots as does Zanen Electronics.

Bob Roberts is awesome, but it's a bit of a hassle for me to order from him unless I'm buying a lot of stuff to justify it. (buying a money order, waiting for snail mail..) The company I work for has accounts with most parts suppliers and I'm often placing orders anyways, so that's usually easier for me.

Does Zanen Electronics have a parts list with prices available somewhere? I couldn't find a website. Do they ship to Canada? I've got my parts for this monitor covered, (hopefully!) but I have a dead G07 in the garage that I'll need a cap kit for when the time comes to start work on that one.
 
I just finished my cap kit, connected my 48-in-1 and plugged in the monitor... IT'S ALIVE!!!!!! I still need to tweak the picture a bit, but this previously 'dead' monitor now works! :biggthumpup:

The only electrolytic cap I didn't replace was C605, the giant 4-pin 330uF 200V on the main board. I ran out of solder wick and couldn't get enough solder off the pins to get the damn thing out. Should I try again to replace it now that I've still got the monitor on the bench, or will this likely not give me problems if I just leave the old one on there?
 
Back
Top Bottom