BunkerFromNLG
New member
Hi,
First of all great website and am very happy to be here!
I have a 19" Makvision LCD with the Model:MT35191B1-0A 12v monitor.
One of the chassis boards on the back is labeled as:
MT35 Series Code Version: 70319B AD35 Ver: 1.0C
On the VGA header housing there's a sticker that says:
TFT-LCD Control Board AD-35C6P3
This is the board where the 12Vdc gets plugged into
and contains the VGA/CGA and OSD board headers.
From here it goes into another small board that have drive
connectors to the back lights and LCD screen.
I swapped out the AD-35C6P3 or AD35 main board with a new one
and everything works fine now.
I definitely see an overheated 3.3V IC component called a 5A Low Dropout Linear Regulator
in a TO-252-2 IC "S2" package, labeled as: AZ1084D 3.3E1 540BJ
This part is soldered into the U6 location.
Should replace this burned looking Regulator?
Also, other than Makvision themselves ( I have their website link already...)
Is there another source for these AD35 boards that anyone might know of?
Attached below is a couple of pics of the board in question...
Please click on them to enlarge if needed! >>>
Thank you in advance, for any help you can give me on this.
First of all great website and am very happy to be here!
I have a 19" Makvision LCD with the Model:MT35191B1-0A 12v monitor.
One of the chassis boards on the back is labeled as:
MT35 Series Code Version: 70319B AD35 Ver: 1.0C
On the VGA header housing there's a sticker that says:
TFT-LCD Control Board AD-35C6P3
This is the board where the 12Vdc gets plugged into
and contains the VGA/CGA and OSD board headers.
From here it goes into another small board that have drive
connectors to the back lights and LCD screen.
I swapped out the AD-35C6P3 or AD35 main board with a new one
and everything works fine now.
I definitely see an overheated 3.3V IC component called a 5A Low Dropout Linear Regulator
in a TO-252-2 IC "S2" package, labeled as: AZ1084D 3.3E1 540BJ
This part is soldered into the U6 location.
Should replace this burned looking Regulator?
Also, other than Makvision themselves ( I have their website link already...)
Is there another source for these AD35 boards that anyone might know of?
Attached below is a couple of pics of the board in question...
Please click on them to enlarge if needed! >>>
Thank you in advance, for any help you can give me on this.
Attachments
Last edited: