Search results for query: *

Would a 25” K7000 chassis work in a tube/yoke/rings where a U5000 chassis was installed? I understand that I would need to add an isolation transformer. Thanks

Yeah, the wires are fine. If I bend the board slightly, red comes back until I let go. It’s got to be a bad connection somewhere else. I just can’t figure out where.

So I ran jumpers and retouched a lot of joints but unfortunately I can’t get red to stay steady unless I kind of press on the neck board from the edges. Blue and green are fine. It’s a broken trace somewhere but I can’t find it. I’ve attached pictures for your viewing. Hopefully someone can...

Thank you guys. I will give it a shot.

Anyone know where I need to run the jumpers from/to on these lifted traces? Any help is greatly appreciated. Colors keep going in & out. If I press on the neckboard, the colors are fine until I let go. I'm guessing that's the reason.

Anyone knows which pot on this Midway Space Invaders chassis I have to adjust to move the picture up or down? The side knobs don’t do the trick. Please help. I’ve attached some pictures Thanks for the help

Thanks for the reply. Much appreciated

Is this a cga or medium resolution chassis? I’m hoping that it’s cga or if it’s not, is there a switch on the chassis to make it so? Thanks for help

Much appreciated.....

Anyone knows what CR # goes with tube model 54SX538Y22-DC01?

Thanks for the info

Need some clarity from the experts. Any help is appreciated Is this a monitor isolation transformer?

The attached image is what I’m supposed to be getting. I ordered what was installed which was a 4.7uf. Perhaps I need to order the 6.8uf. I don’t understand the ‘high frequency’ reference. Can you send me a link of what you have? Or if anyone else can chime in.

The stuff I ordered from digikey popped within a few hours. Need some high frequency stuff but don’t know which to order. Any help is appreciated

Can someone point me to a link or two where I can order a ‘high frequency’ bi-polar 4.7uf or 5.6uf or 6.8uf 50V cap. Apparently a ‘regular’ bi-polar won’t do the trick. Any help is much appreciated.

Anyone knows the answer to my question on the post below? Any help is appreciated https://forums.arcade-museum.com/showthread.php?t=416667

Isolation transformers too close to the monitor will also cause this issue. It's happened to me.

Much appreciated.

Appreciate the information. So it looks like the below link is the correct capacitor to order. Correct me if I'm wrong. Thanks http://www.digikey.com/product-detail/en/epcos-tdk/B32613A1153J008/495-3591-ND/1647872

ok, I'm officially confused. Is below what I need to order? I just want to make sure that I order the correct capacitor to replace mine. Thanks http://www.digikey.com/product-detail/en/epcos-tdk/B32613A1153J008/495-3591-ND/1647872