Search results for query: *

Would anyone be willing to service the board for me?

After reseating the eprom chips it hangs on this screen…. Tested all of the buttons and held them for a decent amount of time and it hangs on the attached screen.

Link to a video of the loop.

I have a US Games Incorporated Super Duper Casino tabletop arcade that when on startup just loops of the startup screen. Any help would be greatly appreciated.

I have a non functional DBA that I'm trying to switch it for a working DBA but have a question when it comes to the wiring. It's a 110v DBA that hooks to a power power outlet, I just need to figure out where the remaining wires hook up to. I am pretty sure they're the credit wiring to tell the...

Put a 2 amp slow blow fuse in the supposed fuse holder area photographed above and started up the DBA and now the Input/Output is displaying a “9”. I manually moved the gears and the DBA cycles for about a minute or so and then displays a “9” again.

Go back to an original! I have this which is fully functional.

I have the attached DBA stack that is not currently working (photo #1 and #2). It's currently installed in a Rockola jukebox that is attached to a Universal Input/Output unit that is displaying an "7" after startup (photo #4). I checked the belts and they seem to be intact and still turn when...

Found out that the issue was the the resistor at location 383. When I went to change out the existing one it literally fell apart. Thanks Pete for the parts and the help getting it back up and running!

I’m not opposed to sending it to someone to have fixed…. Need to finish this project.

I’ve got a 4-board DK PCB that I’m getting very little to no sound on. Graphics are fine. The only sound I get is when jumpman is walking. I attached a link to the video of the gameplay. Anybody have any suggestions? Thanks. Link:

There power to the motherboard and there’s a running LED light on the board just not on the front green LED.

Ok hooked up a vga monitor and powered on the PC and have nothing come up on the monitor. Tried replacing the battery on the motherboard and still nothing comes up on the screen. Also the troubleshooting attachment that was sent mentions that the front LED light (attached photo) should be on or...

I’ll take a look. Hopefully it’s just the 2032 battery.

Bio settings? I’m assuming I’ll find these by going through the troubleshooting suggestions that Algo attached.

Checked power to the PC and the motherboard is getting power and it feel that the hard drive is spinning. There’s also power going to the Jamma interface PCB. It doesn’t look like I’m getting anything from the Disc Drive. The reason I say this is I don’t see the front LED coming on and I’m not...

I’ve got a Chicago Coin Arcade Legends arcade that turns on, but that’s pretty much it. Checked the fuses and everything is sound. Checked the monitor and it looks to me based off of the photo that it is working.

Adjusted the suggested pot and voila! Thanks to all that helped. Really appreciate it!

I’m on it. I’ll try this when I get home. Thanks brother

Would anyone happen to have a good reference point on a live picture they can clarify exactly where this pot is? I just adjusted the v-hold on the 5 above shown pots.