Search results for query: *

I used Elektronforge back around 2006, though I'm not sure if they still repair them or not. Might be worth reaching out to them. http://www.elektronforge.com/

I took a working G07 from my Klax and put it in the Sente cab. Plays blind and no neck glow. i presume that the G07 chassis from another machine should be plug and play.l and should work if the tube is good. If so, tube appears to be shot with some pretty bad burn. i do have a spare 4900...

Picked up a Sente cab recently and removed the monitor to make the machine lighter to move downstairs. Upon reinstalling. I noticed the right side appears to have broken glass inside? Can’t say I’ve ever seen this before I haven’t powered on the machine as of yet as the G07 chassis is out for...

Using a Gimme a break control panel and a mini golf board, is the game fully functional minus the 3rd and 4th players?

Can anyone please post or send a pic of how the marquee light is mounted in your machine? Thank you

RAM replaced. Error no longer appears

So I picked up a dedicated Space ace that was complete except the monitor and NTSC card I purchased a reproduction NTSC card and installed a 4900 with the proper wiring for both. It's currently using an LDP-2000 and hi-tech conversion card. I hooked everything up and while I can play a game...

Can you recommend a good place to purchase them?

Tetris experts…. In the test screen, I get RAM at 40B bad. The game plays fine from what I've seen so far. From what I'm reading it could be a bad HY6264-P12?

Reach out to mikerk He repaired my cockpit pcb previously Highly recommend

I sell the Sprint to Paperboy Adapter

Well as silly as this sounds and I've been in this hobby since 1993, I never knew this could be done. Though it's only been the past few years that I've tinkered with monitors. I rotated the yoke and it's not perfect, but much better. Thank you

Should have posted in monitor section.

So I'm trying to fine tune Smash TV with a K4900. It's a 4 pot chassis. Are all 4 pot chassis interchangeable with the 4 pot yokes or are they specific? The picture seems slanted especially noticeable on the bottom. Higher on the left and sloping to the right. Tinkering with the 4th pot (I...

I borrowed a working 4900 from my Sente cocktail and put it in the smash tv cab and it pulsates. That 4900 had an overhaul done awhile back and never has pulsated before

I'm having an issue with a Smash TV 19" cab that's driving me nuts. I'm hoping someone may have some advice. Both Smash TV and Total Carnage pulsate back and forth. 3 videos below. I've adjusted the power supply 5v and it still pulsates. If I put a TNMT in the smash TV, it does not...

The thread length on the short buttons is 5/8” Anyone know what the thread length is on the long leaf switch buttons? Thanks

Thank you. I was looking in the manual and didn't find it. Looks like it was at end of the manual buried in a wiring diagram Though I can’t find the joystick pcb with any markings of P52A & P52B

Yes thank you. So your pic show the left connector with a blue wire and the right connector with a yellow wire. Do they have to be installed this way or can you move the left connector to the right and vice versa?

Can someone please post (or message) a pic of the 2 plugs that go to the joystick pcb? Many thanks in advance