Search results for query: *

Most older redemption machines are mostly mechanical with a PCB that mostly just controls the motors. And switches. You can find older ticket games for sub $300USD pretty easily on Facebook marketplace.

Hammer DX is a fun one its like a digital whack-a-mole that can either dispense tickets or prizes. It's a little wider than a traditional cab but it's short and on wheels so moving it around is easy. Fun-E-Ball is a little on the tall side but it's skinny and also can do tickets and prizes...

Glad you got it fixed! I had one up until a few months ago but it wasn't making enough for charities to justify taking it to events. The voice chip in mine was going bad so it sounded haunted and I thought it was funny when they gave it the nickname Annabelle.

I have a similar question but from gen 3/4 to a gen five I have 2 gen 4 boards that are having issues and I'm getting tired of fighting them.

just avoid 3rd/4th gen boards currently have 2 with the same mystery issue with brand new bridge rectifiers testing bad on the boards. also replacing components on it isn't cheap and the circuit diagram is practically useless.

Thank you so much I didn't even think yo check the harness. I also checked the line voltage and it came back at 117 so that was fine however there is a short in the claw cable that I will have to trace.

I have 2 Clean Sweep boards that are both having issues with the potentiometer overheating. I have replaced the pots and the bridge rectifiers on both. On board 1 the claw isn't closing so I think the claw relay burnt out but before that the pot was over heating. On board 2 when I test the new...

the easiest thing would be to check the coin switches to make sure they are plugged in in the NO position. I've run across some machines where they were plugged in in the NC position so it just endlessly coined up. if not that you may have a short in the wires or possibly at the board where the...

does it only do it one time or does it do it continuously?

Honestly I have a 24inch S&B prize rocket candy crane and it can hold about 2 standard kitchen garbage bags of 6inch plushies. All I had to do was change out the claw and it works great. I also use mine for Halloween. I set it back to a candy claw and set it out for kids to play. Don't mind the...

make sure you have the correct chip set in your board BA4US4F should be the correct one they had an earlier model BA4US4C that had a different prize screw setup and they are incompatible with each other.

It almost looks like an old vending machine T-handle lock.

Did you need some help? I can send you pictures of mine if that helps.

absolutely! I can also send a pdf of the manual if you need one. though that would have to wait till I go into the office Monday so I can get it scanned

picking up a pokemon catch, vintage clean sweep, and hammer dx tomorrow

heck yeah!! I have 12 redemption games I use to raise money at events for charity! I also have a couple old EM pinball machines (bally bow and arrow, gotlieb crescendo) that I enjoy playing as well. My collection is as follows. flamin finger, pattie cakes, fun-e-ball, slam dunk, knock it off II...

I would just install a new claw you can find the relatively cheap in amazon. Plus you can get them in different styles and sizes. I've bought 2 different styles off of amazon ( 3 prong candy claw, and a 6" plush claw) and both work perfectly even after running for 4 years and constant full...