Search results for query: *

So i found this vendor sells convergence rings. https://arcadecup.com/ Anyone swap them out ever?

So when I looked the clamp, where can I safely manipulate the yoke assembly while it is powered up?

I suspected as much. On a positive note if i can sort the degauss issue, I can live with what I've been able to adjust to until I can find a suitable swap.

I went ahead and ordered a degaussing ring to test this theory further. The rings were marked, I assume by the factory, with a white paint stripe. As noted in the picture, one rings mark was misaligned. I tried returning it inline with the other marks which made the picture worse. I got the...

Just to verify wiring. Game is NHL Open Ice. This isn't the original monitor, or so i assume, since a u2000 monitor manual was in the cabinet with manual. Game is wired using - ground sync. I assume its correct as I get picture? The degaus is the ring that is routed behind/around the tube...

I cant say for certain on that. Im a rookie that hasn't encountered this before. *after thought. Thinking about your theory perhaps you're on to something. My othet crt games have an audible sound at power up. This powers up very quietly. Is that degaus cycle normally audible? That said I've...

Looking at convergence rings I can see from the white mark at least one ring has been altered significantly. I realigned the one off and see no improvement. Worse actually. The videos I saw discussed loosing the ring set screw and moving the stack fore and after. Is the screw directly center...

Thanks for the help. Ill watch some tutorials on that.

One more thing im noticing is when the display changes from a full screen image to another the overall image will shrink for just a split second and then return to normal size. Also when adjusting the screen pot on the flyback, the image size does change a bit vertically.

Kind of hard to show in a picture but this is the best image I could get. Also im seeing color changing on the top and bottom edges of the screen in color test. Its similar across red green and blue.

Monitor had bad flyback that took out the HOT. Flyback replaced, cap kit and new HOT installed. Monitor powers up fine. Now trying to get it adjusted. The image is sort of twisted counter clockwise. Ive played with all the adjustments on the remote board along with the horizontal hold on the...

Fair enough. I've got the cap kit in the cart. Was hoping to see it I needed anything else before placing the order. Any other reccomended replacements for the D9200 when I do the cap kit? I did find the reccomendation to reflow transistors on the neck board but haven't found many other...

Good deal. Any input on my resistor measurements? I'll replace that cap when I do the cap kit on the chassis.

OK so I'm going through the sync board resistors and think I'm finding some issues. That said, I know a little less than nothing about CRT chassis. Testing through them with the fluke I find the following odd (to me) readings. Loc, manual spec, (actual if different from manual), reading R524...

So I have revision F board in mine. The cap is definitely suspect. I'm going to run through and test all the resistors as well while it's out.

I'll take a look at this for sure.

Well that's not reassuring. If the caps are crapping out why's the pic going dim and red 🤔

Have a D9200 in a Golden Tee live. Screen displays but is dim and a bit washed over in red. Looking at the board I see a few caps are gone and have leaked significantly. What are my odds that a cap kit is going to resolve my issues? I'm debating between trying a cap kit or swapping to a 4:3...

Just to make sure were discussing the same thing. You're referring to the test switch attached to the main board, not some test switch on the chassis i'm not aware of?

Never would have considered that a possibility