Search results for query: *

Patient: K7000 P538 Symptoms: originally the B+ read 150 to 160 V, HV shut down. Performed the light bulb test and got close to 130 volts. So the issue is on the horizontal side. After visual inspection, I noticed that the jumper that's below the yoke connector was partially removed. So one leg...

Symptom: Had a K7300 that worked but when it warmed up the screen would shake. If I adjusted the vertical size it would go to a thin line like collapse. Solution: caps and c371.

With a bleeder box and the vertical PCB. I have a 27 inch that has the width coil on it and I seen the P612 board but I think this one’s the first

Patient: k7000 25" Latest version produced Symptom: vertical collapse 1st thing I do is test to see if I have the 26 volts on both pins of ic3 that require it. It did, so I knew everything was good up to that point. I also checked for bad solder and bad pots around the vertical pots. Also...

It’s always the small Things that cause the biggest headaches

Took 2 hours to do. Take your time so you don’t lift any traces. Ready to go and for sale after burn in period.

Patient: K7203 Symptoms: 1. High b+ 139 and not 121. Couldn't adjust down far enough. 2.Squealing / High pitch sound Solution: replaced cap c009 22uf. Caps on these usually fix a lot of issues but just replacing c009 fixes the noise and the b+. I was able to adjust b+ enough once I replaced...

So nothing of late to log here but thought I would post anyway since this had all types of issues Patient: k7400 Initial symptoms: Dead Performed lightbulb test and got zero voltage and no ticking. Of course, I checked the big white resistor and all that good stuff before doing the...

You just have to know where to look...

What about ssd upgrades?

Damn Same issue here

Are you running all them thru the converter board?

What chassis is it?

Nice

I just pushed down on all the sockets As suggested

Fixed

Hmm. I have this same issue too

I have a client that wants there's fixed bit I do not do PCB work. I do only monitor boards.

My 4 slot just refusing to work anymore. The pins are just horrible. Any suggestions on a repair or replacemet? I may just have to buy another top board. Anytime I want to change games it's a hassle. Both the cart and slot has been throughout cleaned.