Search results for query: *

If anyone has a complete, with lid, message me, thanks!

Anyone has one to sell, PM me, thanks!

Anyone know where to start on this? Worked yesterday, turned on and its repeating sound effect and screen went blank. see here: Problems

Finally got my Tempest restore working but some issues. I have Jason Kopp tempest board and IM wondering what that runs under load? I tested the 5vdc on the power board disconnected and was getting 5.3v. When I connect the board Im getting 3.8v. Reason I even checked is because Im getting some...

I bought a new harness for my Tempest restore. There are 4 wires zipped along with the two that connect to the volume pot. What are these and where do they connect?

Can anyone tell me the part numbers to these two connectors and where I can order them? I ordered the 15 pin Molex but it is not keyed like the Atari one so it doesn't connect. The other runs into the coin door. Thanks!

Trying to finish my restoration and need this monitor bracket. Let me know if anyone has one to sell.

My AR II Tempest board doesnt have any of the test point "Lugs?" installed. I would like to run a 12v fan off this board as well as for testing voltages. Does anyone sell these that I can add to my board or have a solution? Im a newbie and every video I see testing voltages are hooking up to...

I want to add a powered subwoofer to my Tempest cab (output from Arcade Jasons board) and a 120v fan and need to know if this is a good idea to add an outlet in the cab? Can I run the power cord into a fuse block like the one pictured and bridge, then from the block running to the new outlet and...

Watched @ArcadeJason yoke wind. Using a NOS tube. This has different posts than Jasons video. What posts do I wind the left and the right coils to? Original was using all 3?

Anyone have some detailed images of the guts of the machine? I have an empty cab and am getting new harness and repo everything for the most part. I have the manual but Id like to see some original images for wiring etc. I dont want to blow something up when I power on. Three additional...

Working k4600 chassis that I picked up a year ago and never used. Bought working but never tested. Asking $150 plus shipping.

Self test switch Volume with mount Power on/off with plate carboard bezel (reproduction or new looking old stock) I have one but its rough coin mechs interior monitor mounting bracket Reproduction serial tags for back of cab

Im in need of a working tempest power block for a new build Im doing.

I bought an empty tempest cab that has the monitor but no power supply, PCB or amp board. I think Im going to pick up Arcade Jason's tempest multi board. Question is, can I get a modern power supply and which one? I found the amp board on Ebay. Is there anything else I would need outside of the...

Anyone out there know of a builder that sells or has a good used one?

Looking to pick up a working Tempest with original working parts and good vector monitor. Any idea what this is worth? I want to make an offer so if anyone can give me a good starting point. Thanks!

Im going to be hooking up my mistercade Jamma to k7000 video input. Question is to sync do I have to add a jumper wire to the 2 sync inputs or only the single +H sync like the picture attached? A little confused as there is only a white wire for syncing coming from the Jamma harness. Thanks!

I am replacing a couple rusted chips that have come undone but need to know for sure if these are the same? Its from a Donkey Kong PCB. Thanks!

Recapped Sanyo amp and replaced the 383 resistor. Recapped sound board and replaced the amplifier circuits (C1815), tested the cables for correct voltages and still no sound. Replaced the sound chip (z80) as well. No hum from speaker. Im stumped. What Im not sure how to do is check for power in...