Search results for query: *

Saw this on ebay (not mine) for anyone looking for a Tempest project. It's been converted to neo-geo. www.ebay.com/itm/131847160197

Obviously your B+ is too high, but try turning the screen adjustment to see if you actually do have a picture. Are you sure you have your HOT installed the right way? The legs need to be centered. Make sure there's no shorts.

Don't worry I got one. :) I plan to attach it with some double sided foam tape, but can't find my roll of it :P

Got some work done on Stargate last night. Installed my joystick. I used the rebuild kit from arcade shop + a NOS stick from a member on here. Wired up the control panel as well as the main control panel harness. Mounted it in my joust for testing, threw the stargate boards in too. Everything...

bump bump bump

Wiggle your ribbon cables. Mine would go from all systems go to rug pattern. Ribbon cable was iffy

Typical wear $55 + shipping

Anyone know someone that sells these? Mine has a big crack in it. I am not looking for a horizontal width coil, this is a different part. The part number on mine is A39835C. It's located at L502

I think I've figured it out. From what I'm reading it seems to be a horizontal linearity problem. The linearity coil (different from the width coil) is supposed to handle horizontal linearity. Mine has a big crack in it's casing. Anyone know where I can buy them? It's part number a39835c

graphics are better on rush 2049

rush 2049 by far

In the future you can use http://romident.coinopflorida.com/ to identify roms

So I got some work done on the control panel. Patched a few remaining spots with Bondo, rock hard wood putty, and sanded it with an oribital disc sander using 220 grit. Spray painted it with Kilz sealer/primer, then painted the back and edges with some flat black. Painted about 1/4" of the top...

I could use them as well. So if I understand this right, the overlay doesn't stick to anything there, just hovers above the washer? Seems like a poor design. Seems over time, the overlay would develop stress cracks there from people's fist resting on the control panel, while using the joystick.

I saw some pictures of those online. Wouldn't the overlay stick to the dust washer then and not allow the washer to move? The dust washer's opening seems to be only as wide as the joystick shaft, so it seems like the washer would need to slide freely. The only solution I can think of is either...

Talking about this spot here. Do I trim this out? Or what goes under it

I'm restoring a Stargate control panel. I just applied the overlay, but there's about a 1/4 inch gap between my metal joystick housing and the control panel overlay. What is the overlay supposed to stick to above the joystick? It seems I'm missing something.

It seemed pretty even. I loosened the yoke just now and tried to adjust it out. However, it seems that no amount of positioning will get rid of the shrinking. I played around with the horizontal freq and it also had no effect on fixing it. :/

The replacement tv tube is 90 degree. I'm not sure what the old tube was, but it had lots of pac-man burn in. So probably whatever pac-man games came with. It had to go back a little bit more than the original tube had it. I attached some photos, I'd say it's probably average distance...

I should probably clarify. I mean the yoke is from the g07, but the tube is from the tv. The impedance was way off on the tv's yoke.