Search results for query: *

No bulging or burnt looking caps...

I'm getting 5.02v, and around +14.2 and -11.3 on the unregulated 12v. Does anybody sell a cap kit for this board, or do I need to lookup the values and order them individually? I guess a new bridge rectifier might help while I'm ordering parts...

Ok. I tried reseating the ROMs and the ribbon cable. I don't see any corrosion damage, but I'll check it again. I'll also check voltages when the sounds are working and when they go out. Thanks!

I have a Data East Hook pinball, and the sounds will sometimes work. Usually the music will go out first. The other sounds will usually work for a little while before they stop, with the voice sounds going out last. After it sits, sometimes when I turn it on, all is working for a litter...

Thanks everyone! I'll start patching the cabinet, and order me a pair of 4" sticks. Now to decide what to do with the control panel...

Looking for advice on a Robotron restoration for multi Williams I recently got a converted Robotron I am restoring. I want to keep it looking like a Robotron, except for the control panel. I have a few questions. On the bottom of the cabinet (see picture) there is a board that doesn't seem...

Just got this multicade finished and delivered in time for Christmas. My customer requested hickory veneer, and though I was reluctant at first, I think it turned out looking great. Usually veneer is run long then trimmed back, but I was unable to remove the back section or the control panel...

Bump because no replies...

I have a Neo-Tec 2702 monitor that when powering up cold ticks, a little more than once a second, for about 20-30 seconds, then comes on and the picture looks great. If I turn it off, then back on shortly after, it only ticks a few times. Is this a sign of something going bad? The flyback...

I may end up doing that. It looks like each switch gets a different value resistor inline to ground. If someone has a spare, I'd rather buy that. Thanks!

Thanks. I know it's a long shot, but does anybody have one they are willing to part with?

I'm working with a Neo-Tec 500DX. The picture looks good but I need to adjust both the horizontal and vertical positions. It doesn't have a remote adjustment board. Should it have one with either pots or buttons for menu driven adjustments?

I reseated all 25 ICs several times each, and now it works fine.

I could go that route, but I prefer one that is CNC cut so I don't have to mess with all of the rounded corners.

I have a Time Soldiers PCB that keeps showing sprite RAM errors for RAM 1,2 and 3. If I go into the service menu and then exit, RAM 2 and 3 will show OK intermittently, but never does RAM 1 show OK. Does anybody know which three ICS on the PCB these are? The only manual I can find online does...

Does anybody make a cocktail cabinet kit that has side controls for two players on horizontal games? Or a kit that has both side controls on one side, and control panels on either end for vertical games (1 player up at a time, screen flips for player 2). Dream Arcades has a cabinet like the...

Need help with Sega Goldeneye magnet processor interface I am working on a Sega Goldeneye pinball and have issues with one of the columns on the switch matrix. Three playfield switches and the two magnet switches. When the magnet processor interface is unplugged, the three playfield switches...

Still available...

bump......

bump.......