Search results for query: *

Here's another tip for anyone who wants to calibrate the tracking range of his 467. The tracking calibration doesn't necessarily have to be zero, just minimum reading. I've received this response from B&K Precision after I sent them an email about this. Now I have to get to the electronics...

I've put dirty pcb's in the dishwasher many times too. Never had any problem so far. First I remove stickers, then spray some windex on it, then turn on the dishwasher, no dry cycle. Afterwards I blow out the water with compressed air and let them dry further near a heater vent for 24 hours (or...

Ok thanks, I'll go ahead and order new electrolytics. So when the unit is funtioning properly it's supposed to reach zero when calibrating the tracking? And the needles are also stable?

Ok, thanks for all the tips. I know to use clean & balance first, I followed the instructions this way. I started the tracking range calibration: -100K resistor between 'Red K' & 'Blue G2' -Set 'normal'/'high' to normal -Set to TEST -Turn Red G2 until dial reads 2.0 on upper scale (full scale)...

I already checked the heater voltage according the manual: on the tester 6.3V on my DMM: 6.7V Could this be the problem for the busted green? Heater voltage too high?

Thanks for all the help guys, I can get started with the solder reflowing and calibration now.

Can anybody point me to a location where I can download the service manual for the BK467? I have lots of free time this week so I'm going to reflow the solder joints and maybe recalibrate (that's why I need the service manual) this tester if necessary. Thanks.

Yes, there are 2 options: "CLEAN/BALANCE" & "REJUVENATE" after 3 failed attempts at clean/balance I switched to rejuvenate. Had a few goes there, but still nothing.

Ok, thanks for all the info. I'm soon going to test 2 WG K7000 monitors from the Sagaia cabinet I acquired a few days ago. IF I have to rejuve I hope everything works out better than with the vga monitor :)

Thanks for the info. When you say rejuve, do you mean you use the rejuvenate setting from the first time or clean/balance setting first?

Yes the tube was only to do my first test with the BK467. Heater voltage was set to 6.3V according to the manual for this tube. G2 until the needle moves 1 division. Right? The tube was indeed discharged, and I laid it on a towel with the screen down to connect the CR-socket and all the...

Yes I did, and like the manual says, switched over from clean/balance to rejuvenate after 2 times. But no luck, needle stays very low. I did see a little green when entering the service menu on the monitor and cranking te cutoff to max value.

I hope you're right, this first rejuve attempt didn't really make me confident for a real rejuve on an arcade monitor...

I recently acquired a BK467 rejuvenator, I have an old vga monitor (LG tube) that suited fine for the first test. Blue & red were ok (green zone) but green was pretty weak (yellow zone). I tried the clean/balance option (push green button and let the needle drop to the red zone according to...

As in the title, I'm looking for CXK5864BSP-70L (sony) HM53461P-10 (hitachi) HM53461P-12 (hitachi) or other brand substitutes. Thanks, Kevin

Hi, I am looking for following ram chips to repair a T2: CXK5864BSP-70L HM53461P-10 & -12 Is there anyone who can tell me cross reference part numbers for these chips? The sony CXK5864 is on eBay but it has a slower 150ns timing, will that work...