Search results for query: *

Anyone taking in repairs for 19K7000 P447 Medium resolution chassis? Or have a working one for sale? I have a Toobin that is now playing blind. I don't have the time or the room to do my own repairs at the moment so I am looking to outsource it or just replace it.

Thanks Andrew. It ended up being R610. When I pulled it and 710 to retest, 610 was definitely bad. I went ahead and replaced both and I am up and running again.

I didn't check the board set yet as I would think the spot killer would come on if the chassis was not receiving deflection voltage. But I could be wrong. I will take a look at the board set. I tested most of the resistors in the vertical deflection circuit but I plan on going over them again...

I have a WG6100 in a Star Wars that has collapse. I see the game playing in the single horizontal line across the middle of the screen. I have test/checked the following: All frame mount transistors test good All frame mount transistor connectors test good Q603/604 and Q703/704 test good There...

I am interested. You can PM me with an asking price and pictures.

There were different boards. Namco and Atari. All of the eBay listings are for untested Atari boards or the JAMMA board. I am looking for a working Atari video board or a complete working set.

Not interested in untested boards or the Namco boards. But thanks.

I am looking for a working Atari Xevious video board. I would be interested in a complete board set if a only a video board is not available.

I do not see any damage. So I can test the transistors in circuit? One thing I noticed is that when I am checking voltage on the blue test tab, I get a consistent voltage of ~3.5V. But when I test red and green, the voltages vary as the game runs and they don;t seem to go over ~1.5V

I have an Atari Xevious board set that is having color issues. I have narrowed it down to the video board by swapping out with a known good one. The colors are wrong (too much green and blue). Not sure where to start. I no longer have access to the working video board. When I had access to...

PM'd you .

Looking for working 19" GO7 chassis.

Selling only as a lot? Or are you open to sale of individual items?

Yes. I keep a stock pile of 20A fuses.

I have a Williams Scorpion that blows the general illumination fuse (6F1) after a few minutes of game play. This is my first and only pin and I'm not sure where to start.

Have you tested the monitor in another game? That would eliminate the monitor as the issue if it tests fine.

Thanks guys! I will get one ordered.

So the connector on my harness that plugs into the motherboard is pretty corroded. Are there replacements for these available?

I found this thread so I think I am good. Thanks for the help Andrew! https://forums.arcade-museum.com/showthread.php?t=212420

The entire boot has disintegrated on the flyback side. It is super brittle. Should I solder the diode on then encase in epoxy? If so, what kind should I use?