Search results for query: *

Ok...so..just like magic, poof- it fixed itself...no idea what happened but it’s working..for now . Thanks !

Pics of adjustment board located off front - couldn’t get anything to improve. - not sure where the other adjustment you’re talking about next to the heat sync. Here are a few more pics - - if I’m not seeing it can you point out in my previous pics above pls. - also - note the component on...

pics ...murphy's law is that you can't see what you want with the pics i took...

point me in the right direction please - monitor diagnosis This is an arcade legends 1 with 32 " monitor that i can't figure out what the root cause of problem. not sure if this is related to the daughter board, or the monitor board itself. The monitor is 2004 and made by Samsung. The...

hello and thanks in advance for the help. new to me game that the computer comes on for a few seconds and then nothing. Im assuming that the power supply in it is bad. I thought i could just buy an inexpensive replacement, but there are an awful amount of wires coming out of it. any...

Ok so rather than spend too much time trying to redo the first chip, I should move on to the next bad and replace it. It must be Murphy's Law that the two chips that are bad are soldered in vs sockets. At the advice of another I am installing a socket on the next one in case it were to...

So let me clarify If there are existing error codes, should the game beep say (3) times, pause, and then move on to next error code ( in this case next is 8 beeps) OR does it work that I get 3 beeps, make repair, and then the game moves forward to next error code? Which makes more sense...

I had 3 error code beeps -ordered replacement chip and soldered back in. When I turned game back on I then had 8 beeps. Same chip part #, new location. My question is : Does this Atari game give all error codes in succession at start-up? I don't know if I had 2 defective chips to begin...

Need measurement please..Millipede coin door opening. Thanks in advance.. I am restoring a Millipede and the wood on the front panel is bad. Before I cut the double coin door opening (stock) could someone please give me the measurements from the sides over and top /bottom in? I want to cut...

What to do with Millipede..60:1 complete transplant or ? Hello I am doing a resto-project with my 11yr old and picked up a decent Millipede. As of now we are at "the lights are on but nobody is home" stage. The screen is garbled with vertical colored lines. Pressing front panel buttons...

What to do with Millipede..60:1 complete transplant or ? Hello I am doing a resto-project with my 11yr old and picked up a decent Millipede. As of now we are at "the lights are on but nobody is home" stage. The screen is garbled with vertical colored lines. Pressing front panel buttons...

thanks.. Its the case of being patient. From what I can tell, building a complete new one from parts isnt an option?

. I did a test and found the following: 1) ck sw 53 left ramp enter: - the entrance fence wire was out of its hole, still inop as I dont know if its bent or supposed to be under the switch,,have to find close up pic. 2) ck sw 74 gumball popper (?) 3) ck gumball diverter (?) 4) clock is...

So, I felt like the lady in the IKEA commercials.."start the car! start the car!" I get home and begin looking online at various TZ's, and realize that I completely missing the clock assembly. I am not sure how it will affect game play. Also -I am not familiar enough (yet) to know what else...

I just purchased a TZ and not really knowing anything about it... I now know that the complete clock assembly is MIA. not sure what to do, but I figure I will throw it out there and see if someone can help me make this game complete. thanks! Bc3