Search results for query: *

Hey everyone, I am trying to find a replacement board and/or light sensor for a revolver we have on our Lethal Enforcers cab. The player 1 gun works great and seems to have an updated board in it but the 2nd player gun seems older and only works when really close to the screen.(Even after...

So I have a Gauntlet Legends that hasn't been working in a while. The hard drive crashed on the previous owner and he decided to sell it. I installed a compact flash card and when it starts I get an error message in red on the screen "no valid home blocks found" I cannot find much information...

So, we have a Rampage game with no sound but plays fine until about 5 minutes in and it crashes to a colour'd static screen. And if you reset it, it will crash again in a few seconds until it cools down. I was going to cap it as a shot gun approach, but I was wondering if anyone has had this...

Hey everyone, I am currently working on a Williams Star Gate game and it seems to need all new RAM. (I replace one and I get an error for the next, so on and so on) So it currently has the original 4116 RAM installed but I was wondering if the NTE equivalent 2117...

we have a lethal weapon 3 pinball that had a shorted drive transistor for the out-hole solenoid that pushes the ball out to the plunger. we replaced it and now that solenoid works but we are blowing F5 on the power supply board. we check all the diodes on the solenoids for that circuit, checked...

so I have a Cyclone pinball machine and the diodes across the flipper went and caused the power to back feed. The flipper still worked however but I replaced the diodes but now the flipper is blowing fuses. I have been researching and the new diodes are good but I have no idea what might be...

Joust keeps repeating rug pattern and flashing error The led error display on our joust game keeps flashing and I was wondering if anyone might have any suggestions. http://youtu.be/V2WTm_IG6Ec Thanks

We have a Williams Defender Star Gate Game that had a bad RAM chip. We replaced the chip and now when we turn the game on the monitor only turn on for about 10 seconds and then shuts off with no audio. We are stumped and looking for any advice. Thanks

Hey, Does anyone know the best what to test for a shorted RAM chip in a midway space invaders deluxe cab where all the chips are soldered in ? I am loosing +5V and +12V when the harness is connected to the board but removing the caps at the ends of the ram chips brings the voltage back up. The...

Hey guys, we recently purchased a large sum of random game boards, some work, some don't. And I was wondering what the best way to identify the non working ones would be. I tried googleing the numbers on a few but with no results. I want to know what we have to see what would be worth fixing and...

I have an asteroids deluxe game with the top half of the monitor folding over the bottom half. a fuse was blowing (I forget if it was F100 or F102 ) and found a blown Diode bridge. I replaced the bridge and stopped blowing fuses but I still have fold over. The large ceramic resistors read...

I am working on a original midway's space invaders and it appears to have a dead game board. Everything appears to be in good condition and the monitor turns on but I can not get any sound or video. All the voltages are adjusted properly with the board unconnected but when connected the +5V...

I have a gauntlet Legends game that goes to a black screen right after you select your character and world after the cut scene plays. I have the same results with the original hard drive and a flash card. I have also adjusted 5V with no results. But upon inspection I found there is a pin...

Hey guys, got a good one today. So no one checked up on the machines at the arcade for about 2 weeks. upon checking them for problems Lethal enforcers was on full volume (were talking movie theater THX loud here) and when I went into the settings to adjust the volume, every time I highlight the...