Search results for query: *

  1. WTB: Working Gorf board set

    Looking to buy a working Gorf board set. Thanks
  2. GORF issue

    Thank you!
  3. GORF issue

    Where do you get the GORF Test-ROMs?
  4. GORF issue

    You were right. I switched the ram cards and I have a slightly different pattern now.
  5. WTB: Working Gorf Rom/Ram board

    Hi, I’m looking for a working Gorf Rom/Ram board A082-91364-A000. Thanks, Tony
  6. GORF issue

    Yes, the player ship explodes immediately.
  7. GORF issue

    Does anyone know which one of the boards, and which chip would cause this? I am able to start a game but it ends in about 10 seconds and the ship gets bombed immediately. Also the controls do not work. Thanks
  8. WTB: Dig Dug Wiring Harness

    I have a Dig Dug that has a switcher in it. Inside the cabinet there are a lot of hacked wires, and has never really worked very well since I’ve owned it. I’m looking for the complete wiring harness to hopefully fix this issue and restore the game. Thanks
  9. SOLD - PARTS Williams System 3-7 Driver Board

    Will yours work as a replacement?
  10. SOLD - PARTS Williams System 3-7 Driver Board

    Here’s my Driver Board For GORGAR.
  11. Wells Gardner 19V2000 Blooming issue.

    I did do a cap kit on mine, and I’m planning on reflowing as well. Thanks!
  12. Wells Gardner 19V2000 Blooming issue.

    I forgot to mention when I replaced the HV diode, I Soldered it directly to the wires. The springs were really burned.
  13. Wells Gardner 19V2000 Blooming issue.

    I have a Wells Gardner 19V2000 that is blooming after about 2 minutes of powering on. The image doesn’t get larger than smaller. It gets larger and stays that way. I replaced the high-voltage diode, but I'm still having the same problem. R 100 and R101 are both 4 ohms. The first picture shows...
  14. FS Game: Mortal Kombat (Michigan)

    FS Mortal Kombat Wixom MI This has been sold.
  15. K7000 Screen Issue

    K7000 Issue I think it’s the right chassis. Here’s a picture of the back. It has the separate remote in the Front.
  16. K7000 Screen Issue

    The Vertical potentiometer works, but It won’t Adjust to fill out the entire screen.
  17. K7000 Screen Issue

    I have A Wells Gardner K7000 that does not fill up the whole screen. I followed the Flow chart, and checked the B+ which was normal. I also checked the 2 Transistors Q4, and Q7 both tested good. Not sure what to look for next. Any help would be greatly appreciated.
Back
Top Bottom