Recent content by Wayne104

I’m having trouble getting mine to work also. I know the rgb are just matching colors but what do you attach to the other wires the common and sync wires?

Does that ic control both guns or just one. The player two gun works fine and have no issues. Where us that ic located on the board?

Yeah it's definetly bad there's a small hole in the center of it. The numbers off of it are. TDA1554Q N50026 HSH9505 2 Where wod be the best place to buy one of these?

Having an issue with player one gun socket on pcb board. Whenever a gun is plugged in it doesn't recognize the triggering. If I switch the guns they both work fine in player 2. Anybody know what this could be? The gun motion is detected in the test screen just not when trigger is pulled.

Ok thanks that helps to at least know where to start checking.

I have proper 12 volts out of power supply and mono is set. I recently purchased a new board and have the same issue with that one. The way that it's set up is the wire directly from the speakers goes to the board just like in manual. This is not a dedicated cabinet so when the speakers went...

I have an Area 51 and am having some sound issues. The volume is turned all the way up and can barely be heard. I check and replaced the speakers and made sure there 4 ohms. I can't seem to figure out why the volume won't turn up.

Pm sent to you

Marquee How much are you looking to get for the mk1 marquee?