Recent content by waterloobearing

I am measuring post to ground

Measures at the terminal block above the claw. I went back through and reseated all the connections and I can get 50 volts to the claw during game play now. It won’t close. Measuring 17.4 ohms. New to claws so is that good or bad?

Was finally able to take a look at the wiring. Everything looked good. Tried a different new coil too. It gets power to the coil but the minute you hook up the coil the voltage is gone. Has me stumped.

I have done as much troubleshooting as I can and haven't been able to figure it out. Tested the coil and it is good and claw will engage and disengage when not in machine. Resistor at R40 was fried and replaced that with a 1k ohm 1/2 watt. I can adjust the voltage in test mode and get 48v at...

Yes had to change out a few capacitors and got it working. Thanks again. Now somebody hurry up and buy this before I get in trouble with my wife.

Buy with confidence. Just picked up a BSD from Mike a few weeks ago. If my wife wouldn't castrate me I would be all over this.

Just sent you a PM

Just sent a Pm

Cabelas Model 400 is a little over $50 great machine for the price.

Looking for a Williams Whirlwind. Let me know what you have and what you want.

Thanks for the info. I will see what that does.

Screen shows the following message UNABLE TO OPEN BINARY BOOT FILE BOOT FAILURE: PROGRAM LOAD FAILED FATAL ERROR: Failed to load boot file, code 3 Board will reset in 10 seconds Press start to reset Any ideas on what the problem may be? I also attached a pic of the screen Thanks for any help

Looking for a Whirlwind pin in the Iowa area. Have pins for trade or purchase outright.