Recent content by videorob07

Looking for two speakers for a gremlin trapshoot wallgame. They are 2.5" x 4" 8ohm 1 watt. Looked for some online, but no luck so far. Let me know if anyone might have something. Thanks.

Could not find the one without the heatsink. Did find the UA706BPC. Ordered a couple. And some sockets. Opened the game up and checked things over. no loose wires, or broken connections. All connections good. Potentiometer checks out ok. Will replace the audio chip (ua706bpc) and the lm324n chip...

Thanks. I will look into that.

yup. That response was from arcadechips site. Electronic surplus does show the UA706BPC in stock. Going to pull the game off the wall and open the back to put eyes on the board to make sure of part numbers. Also to get the number of the pot that adjusts the sound volume.

There is no product that matches the search criteria.

Does anyone recognize this chip # 706 APC used in a gremlin trapshoot sound board.1975. probably other wall games as well. I believe it as an audio amplifier according to the manual. Cannot find it anywhere online. Thanks.

Still available. Thought I had it sold a couple of times, but things fell through.

I thought I changed that. Shipping is available if arranged by buyer. I can wrap and palletize.

Still available if anyone interested.

Ok. I have to apologize for not checking something first before going into all this. Let me back up. Several years ago the original monitor went out. Tried to fix it, no luck. I had an extra 19" flat screen computer monitor that I hooked into a GBS8200 VGA adapter. Wired it into the video input...

Found pin # on schematic, does not have any voltage. Only a couple resistors 2.7k 5% and a zener IN5231

That 2.8 AC is on the 1.79 dc volt pin Cant find that anywhere on the schematics. Will keep looking.

Ok. Changed meters. other meter was not able to read that low. Now have .001 on 5 volt 2.8 on 4.4 volt .001 on 17 volt .056 on -17 volt

Well, I have been known to measure things incorrectly. Let me double check my meter.

Ok. Checked ac ripple Both PS boards were about the same +5 volt lines are at 10.4-10.6 volts AC +1.8 volt line is at 4.4 volts AC +17.7 volt line is at 26.4 - 36.4 volts AC The rest did not register