Recent content by trissa

I does seem to be the Ribbon cable. Thanks again for the responses.

Cwilbar - Player 2 does not start a game either. Mecha - In test mode none of the buttons of joysticks register. coin slots do. will check ground to widget tonight. any other thoughts while I am hunting for ground issue? Thanks, Troy

Have a Joust upright. Boots fine. I can add credits, but can not start a game. Any thoughts. Thanks

My Joust is booting and accepting credits, but will not start a game. Can some one point me in the right direction/ Thanks

Sorry for my lack of knowledge but what should the logic probing of inverters values be? All of the 2-9 pins on the PIA probe high Pin 4 DAC -.628 How do I check for data on data lines? Sorry Ken for the dumb questions

Hoping someone can help me with a no sound joust. Have no sound at all. does not play any sound when the diagnostic sound board button is push. went thru diagnostic checklist. getting 10v at TP1 and pin 5 IC1 Getting 5 v where I should be power supply is giving 11.7 v @ power supply and...

I would like to thank all of you that sacrifice your time to guys like me that stumble a bit when trying to bring a game back to life. I love this hobby! I have had easily 50 different pinballs and arcades in and out of my collection and would say that not a one of them would be brought back to...

I would like to thank all of you that sacrifice your time to guys like me that stumble a bit when trying to bring a game back to life. I love this hobby! I have had easily 50 different pinballs and arcades in and out of my collection and would say that not a one of them would be brought back to...

Thought I would list this here before it goes to ebay. Working when pulled Jamma board set for a 1943 Battle of Midway upright. $70 obo plus shipping.

Thanks for the reply Cnyncrvr I looks like my 12v is running at 16-17v. Doesn't look like much up stream, other than bridge rectifier. PS has what looks to be 4 diodes but I do not see them on the schematics. will test bridge rectifier

Mark Darts 5000 repair help Oops sorry I see pictures are upside down.

On my Joust the cabinet dado joint depths appear to be a 1/4" deep. If you flip open the control panel and look at the top of the front coin door plate there is a spot were you can measure the depth (or least on my joust there is) and mine measures 1/4". Would assume that is standard thru out...

Have a series 5000 mark darts that I am hoping someone can give me some direction on. Problems. Sometimes is fires up and works and ......... sometimes I get scrambled digits like in the jpgs also as you can see in the picture that one of the caps only has the negative leads hooked up...

IC9 pin 40 and IC10 pin34 start low then stay high. You must have drove right by me... I'm a few miles south of I90 in SW Minnesota.

Thanks for the welcome. Here are the logic probe results 1-L 2- H 3- L > H >L > H 4 - H 5 - L 6 - L...