Recent content by toys4larry

It appears that the power supply is not putting anything out. The light on the board and the power supply are both out and I am not getting any reading on the meter. Are the power supplies repairable or do I just replace? If so , where do I purchase a new one? Thanks

Where on the board do I check? Thanks

Hi, turned on the games the other day and my Hang On motorcycle game would not come on. The yoke is glowing very dim and the marquee is on, no sound. I checked the fuses (OK). Any thought or suggestions would be greatly appreciated, Thanks, Larry

Hi, I am looking to purchase a Lethal Enforcer but the seller said that the sound is not working. He said it was and then it stopped. Any suggestions on what to check for? Thanks

I just picked up a Sega Hang On and was wondering if it can be set on free play and how? Thanks

No Luck. Any other suggestions? Thanks

I am looking at a Chicago Coin Sharpshooter game that needs some work. Are parts available? If so, Where? THANKS for any help.

Come on Kev, your not up for a road trip?

I would probably start with a cap kit for the monitor. Bob Roberts sells a kit with caps,big blue, power supply cord, fuse block and fuses. It's a good start.

OK, I believe that I got it. I soldiered in a jumper wire and it is working great. DogP, Thank you for all the advice and help, otherwise I probably would of thrown in the towel and had someone come in to fix it without this great feeling of accomplishment. The soldier I used has flux in it...

Ok, I flexed the board and the screen came up. I isolated it to a spot and when I squeeze the board from both sides with my fingers the screen comes up, when I let go the screen scrambles or goes out. I do not see any soldier joints at this spot and I resoldiered the joints around it with no...

Can I replace polarized caps with non polarized. I am replacing C90, 92, 93 and 70 on my asteroids board and when I went to the store the only replacements they had were non polarized. The caps are 1 UF 50 Volts. THANKS

I replaced big blue and I did a cap kit, but the kit only had caps for the picture tube board on top. Where would I check the voltage?

I have an asteroids that has been taking longer and longer to warm up. As it warms up the screen is jumping all over the place with lines. After about 20 minutes it plays fine. I took a hairdryer and began warming up parts inside the game and I have it isolated to the main game board. When I...

OK, it seems that this game is a little to far gone for me, and I do not have the time or room to store, so I guess it will become an organ donor. Thanks for all the input.