Hello All,
I have a couple of Xenophobe boards I aquired. I am wanting to be able to put these on a bench to test with my HAS supergun. Does anyone sell a Jamma Adapter harness for Xenophobe or have a good wiring diagram to make one?
Hello All.
Hoping someone can help me with a few questions on this repair of Desert Assault I am working on. First, what is this black rectangular component in the picture? It looks to be short to ground and I need to find a replacement. It is right by the jamma connector. It is the first...
Does anyone have the ROM images for this bootleg Cowboy's of Moo Mesa/sunset riders board? I can't find this anywhere to download it. Use the 3 or 4 Rom identifier sites I know of with no luck. It appears to run Cowboys of Moo Mesa and Sunset Riders with a menu option to choose. The initial menu...
Uggg, was what I was thinking. I just used a soldering iron, solder, flux and desoldering braid. Thought it would be pretty easy, but it didn't seem to want to come out all the way. I added solder to them and then tried to get them out by trying to heat them all enough at once to remove, but I...
I am pretty new to working on pcbs. I had an amp I saw start smoking on a Double Dragon board and the sound quit working. So I ordered a new one and am working to replace. After removing the component, the board looks like this. I think the bottom side looks ok, but the top side especially on...
Thank you! I was thinking something like that, but it didn't seem right that it was just on the one side like that. Great timing. I have my cabinet just about done and was getting ready to finish rebuilding the gun after cleaning everything up. Thanks,.
Does anyone know where the small square plate with three holes that kind of looks like a face goes? I think it goes near the motor, but I can't remember where it went, and the diagrams and pictures I have found don't show it.