Recent content by Thexder

Sure. My board is the same as the one pictured here: http://www.crazykong.com/pcbs/G%20-%20O/GalagaA.pcb.jpg

Can I used parts from this Galaga board on my original Midway Galaga board? They look identical, but the board listed below on ebay seems to have some extra chips (is it bosconian?) Can I swap out parts from this onto my original Galaga board? Board in...

Ok, I have a small issue with my Galaga monitor (which is the original 19" CRT Galaga monitor). During gameplay: the far top and bottom portions of the screen will start to wiggle a little (like I can see the words "high score" shaking just slightly). This will continue until I bang the...

It is a standard 19 inch G07 monitor. I will try unplugging the coil when I get home today. The monitor wobbles back and forth, left to right for 5 seconds only. I only notice the problem when I first turn on the machine after the monitor has been on for awhile before that. If the monitor is...

Whats a degaussing coil? Do I need to discharge before unplugging this?

My 19'' Galaga arcade's screen wobbles left to right for the first 3-5 seconds when I turn the power on. Is this something to worry about? It stops after a few seconds.

Its a G07. After the flyback was replaced last year, it worked great up until about a month ago

If it turns out the CRT emissions are weak, what can I do?

I have 2 minor issues with my Galaga machine that I hope someone can help me with. Issue #1: The monitor takes a long time to warm up. Once I turn the machine on, it can take 20 minutes for the picture to completely brighten and other 20 minutes for the picture to sharpen. Once it does, it's...