Recent content by TheCountRiggs

Just fixed it. Was just a bad PS! Woot woot!

New to 60 in 1's I have the "Arcade Classics" board and when it powers up all 4 led lights stay on, no blinking and no picture comes on the screen. I only have power to the board and VGA plugged in. Also yes switch #2 is on. Also to note I bought a Pandora's Box 520 in 1 and if I plug that into...

Here's what I picked up

Great thanks!

I just picked these up the bottle machine (lift up the top drop in a quarter and a bottle slides to the side for u to pick up.... I think) looks ok inside but overall decent. The 70's can one is at the lock smith getting re-keyed. I haven't plugged either in. Just curious what I should do...

Center sensor and gun please

Man oh man I effed up bad this time. I was trying to clean the sensors on my police 911 game and knocked a small aluminum dish off now the sensors wont work. Man I think this is gonna cost me. If anyone has a set of sensors or if there is some sort of conversion I can do please let me know...

So to be clear am I just reheating all soldered connections and adding a bit more solder to them. This is on the board inside the gun correct?

Hahaha funny enough I was have unsolvable problems with my Police 911 game with the gun. Ever since the heat has been on all problems are gone. LOL

Ever since I kept the heat on out in the garage it seems to make the difference. The gun has been working none stop for 2 days without problems... fingers crossed it stays that way

Also they say the Konami guns are unreliable.

The original Konami are hard to find. There is a few star trek ones out there but not sure if they too would work. They are Konami. I hear the best swap is a happ gun. Ive seen the happ guns installed on these in YouTube videos in real arcades so must be a common swap.

As the title says can any gun be wired up to Police 911 in this case. Could I buy a gun from time crisis 2 or any other arcade light gun shooter. Does it have to be a Happ gun. Can any Happ gun work? Thanks im quite new to this all.

Is the PCB expensive or hard to get?