Recent content by sshaft

Full board shot as well as previous close up

I'll hit up Chris I attached a pic of the battery area of the power board I removed the original battery and cleaned most of the corrosion (It was light) Wonder if some of the resistors are problematic Will post follow up soon

Any other thoughts?? When the glitch happens the high scores are also reset to 2000??? Although the board battery is fine

Anyone in regards to the +5.35 v reading ?? Is that in the normal range

Here's the glitch: (In sequence)

So I tested Position 4(below image)and got a reading of +5.35. -Is that worth of an power adjustment? -would that cause the "reset glitch" seen in this game?

Back in the saddle..Will have a reply /follow up soon

Got it working Soldered a wire that was loose to the 3 pin. Connector on the monitor board Then I think it just needed to warm up a bit No prob on restart Thx

The ribbon cables between the boards correct?

Long time no talk. I moved about a year ago and fired up my tron after sitting idol for a solid year Any ideas what may be wrong? Maybe something jostled during the move I get a grey screen and the block screen All wires/cables seem to be in place?? Thx

Thx helpful!

I searched a bit online about adjusting the voltage on a power supply... http://www.arcaderepairtips.com/2009/07/22/checking-and-replacing-a-power-supply/ I checked my tron and didn't notice an adjustment knob on the power supply am I even in the ballpark??

Ill check both voltage and software and advise ASAP. It seems if too much happens at one time(three light cycles crash at once) it fries...almost an overload of sorts I also have issues at start up Game glitches and hums w/o starting up Sometimes I let run for about 10 sec then start back up...

Ok. Got it :) Thx

What is Cdjump?? where can i find?? Im about to test the boards but will look into cdjump as well... thx