Recent content by spigs838

Gun issue I had the same issue awhile back on mine. I actually took the front of the gun off and there was a screw blocking the end. Also I believe there is suppose to be a glass lens in there. When I cleaned that it actually registered again. Not sure if that helps.

I just started to get back into repairing the motion on my afterburner cockpit. I have the motors out and test them in test mode. When I move the joystick and am connected to the side to side motor, it moves the wheel. But when I move right it moves but not left. Also when I move the...

Drive biard I am still trying to get mine going. I have nos driver boards and need to replace everything on my triac boards. Just getting around to get back into working on mine.

Do you still any guns left or just boards?

Ambulance I wish you were up around Syracuse, NY. I would have bought that thing!

Does anyone know if you can change out the 4500 middle board area to an upgraded version. I only have the 4 games and want to get cricket and others, etc???

Really nobody around here!!

I am looking for any fellow afterburner Dlx owners around the Syracuse, NY area. I am still trying to get the motion correct on mine. All the similar issues as others on here but can't get it right. I have numerous parts and motors but still can't get it going. Looking for anyone close by...

Thanks guys for the help. I think it was just a connection I was playing with some wires and screen came right back. Will check and see what was loose.

Ok so I turned on my OW yesterday and was fine. Noticed later on that the screen was black. Reset it and get sound and hear it startup but no picture. Assume it is something with the monitor but not sure what. Anyone have any ideas what it could be.

It always seems to fail on start up. But in test mode is when I was getting the motion only with one motor. I still to check my connections in the stick. How should I set so the limit switches are not engaged. They are not touching right now, unless they are bad?

But they wouldn't matter if the motors are out of the machine and none of them are engaged correct?.

I will check the wiring harness. I know all the limit switches should be good. They aren't really a factor right now since both motors are out if the machine. Only one motor turns and in one direction. I even switched my triac board???

So I finally got some replacement main boards for my afterburner Dlx. I swapped them out to see if I could get any motion. I have both motors out of the machine just next to it. When I go into test mode it gives me motion when I push forward and to the right on the same motor and no motion...

Where and what time Hey Tim what time is this going to be at and where are you having? Thanks