Recent content by slappy

Are there any reputable repair guys left that still work on these old vetors? I'm starting to just think I should send it off so someone. Any recommendations?

There is no extension between the monitor and board. For good measure though, I still wiggled it around and no change was seen on the monitor. I did notice, that the "spot killer" LED is lit on the monitor PCB. This is lit even though I can see the small picture on the screen. Not sure if that...

Okay, so I was curious about the B+ voltage and did some research and it looks like it should be closer to 180 VDC. I was able to adjust the HV pot and get the voltage inline with specs. It did center the small "box of vectors" (that you can see in the attached pic) on the monitor, but did not...

If I checked it right, I got 150 VDC on the B+

Okay..I havn't had a chance to order anything to replace yet. But, I did recheck the voltage test points on the PCB. All were within 1/2 voltage of specified voltages. I would like to check the DACs next, but I am not 100% sure what I am looking at. Which board would I find these on, and are...

Yes, you are correct. The monitor is in deed a WG 6100.

Will do I have checked some voltages, but it has been a while. I have read that the big blue can cause several problems. The power brick is one of the few things I havn't completely overhauled yet. I felt like it was working OK at the time, but I think i will take your advise and just get it...

I have had this SW for a while now an have made several repairs from the cabinet to the PCB. Everytime I get one thing repaired, I find something else wrong with it. My latest problem can be seen in the attached picture. I am not sure what to do about this problem, and was hoping someone with...